Metrologic Instruments Stratos MS2x20 Series - Manual (Page 10)

5
S
CALE
C
ONFIGURATION
B
AR
C
ODES
Single or Dual Cable Scale Configuration Bar Codes
Pole Display Configuration
The following bar codes can be used to configure a Single or
Dual Cable MS2
xx0.
If the MS2 xx0 is currently in a Dual Cable configuration, temporarily
disconnect the Scale to Host cable prior to configuring the scale.
The MS2 xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the
changed configuration (see page 2).
Scale Display
Single-Line Weight Only
³ 9 9 6 0 0 3
Set the scale to use a single-line weight only
display to show all scale activity.
The single-line display must be plugged into
the Scale to Display connector on the
MS2
xx0 (see Figure 1).
Figure 1. Location of Scale to Display Connector
Scale Display
4-line Price Computing
³ 9 9 6 0 0 9
Set the scale to use a 4-line price computing
display to show all scale activity.
The 4-line display must be plugged into the
Scale to Display connector on the MS2
xx0
(see Figure 1).