Motorola 6803578F61 - Manual (Page 6)

Installing the hands-free speaker in your car
See figure 3 on page 2.
1. Slide the visor clip onto the mounting bracket on the bottom of the hands-
free speaker. To do this, place the loop end first onto the hands-free
speaker and slide forward.
2. Slide the visor clip on your sun visor.
When installed, the Power button must be facing toward you.
The visor clip is reversible to allow placement of your hands-free speaker
either on the front or the back of your car’s sun visor.
Adjusting the hands-free speaker volume
To adjust volume, press and hold either volume button on the side of the
hands-free speaker.
Note: hands-free speaker volume cannot be adjusted during an incoming call.
Pairing your hands-free speaker and phone
Your phone’s Bluetooth feature is off by default. Make sure the Bluetooth
feature is turned on in your phone before using your hands-free speaker.
Please check your phone’s user’s guide.
Before you can use your hands-free speaker, you must pair (link) it with
your phone.
1. Ensure the hands-free speaker is in pairing mode
To initiate easy pairing, power on the hands-free speaker by pressing and
holding the Power button until the indicator light becomes steadily lit in
purple. Then, release the button.
After a few moments, the indicator light will be steadily lit in blue to indicate
that the hands-free speaker is in pairing mode. If the hands-free speaker
does not enter pairing mode, see the Troubleshooting section for help.
5
English