MITSUBISHI ELECTRIC DX-TL4U User Manual

Page 62

User’s Manual

DVRNS (DVR Name Service) Setup Screen

You can register the DVR on the DVRNS server to use DVR name service.

Figure 70 — DVRNS Setup screen.

Highlight the box beside Use DVR Name Service and press the button to toggle between On

and Off.

Highlight the box beside DVRNS Server and enter the IP address or domain name of the DVRNS
server.

NOTE: You will need to get the IP Address or domain name of the DVRNS Server from your
network administrator.

NOTE: You can use the domain name instead of IP address if you already set up the DNS
Server during the LAN Setup.

Highlight the box beside Port and enter the port number of the DVRNS server. The port number
can be set from 10000 to 12000.

NOTE: The DVRNS server settings on your DVR should match the settings on the registered
DVRNS server. Any changes on the DVRNS server might cause improper operation.

Highlight the Use NAT box and press the button to toggle On and Off.

NOTE: When using the NAT (Network Address Translation) device, refer to the NAT
manufacturer’ instructions for the proper network settings.

Highlight the box beside DVR Name and press the button to name the DVR to be registered on

the DVRNS server. A virtual keyboard allows you to enter the DVR name.

Selecting Check allows you to check whether or not the name you entered can be used.

NOTE: The DVR name you entered should be checked by selecting Check, otherwise the
DVRNS changes will not be saved.