Meridian America G68 - Manual (Page 44)

C a l i b r a t i n g
t h e s y s t e m
4 0
This section explains how to use the Sine/Sub/Sens controls
to check for room resonances, adjust the subwoofer crossover
frequency, or adjust the sensitivity of the analogue sources.
To display the Sine/Sub/Sens controls
• If necessary, unlock the digital surround controller as described in
Configuration Wizard , page 25.
• Press More until the bottom line of the display shows:
Sine/Sub/Sens. Clear Store
Radio Trifield 65
• Press Sine/Sub/Sens.
The bottom line of the display shows the Sine/Sub/Sens controls:
Sine -Xover+ -Sens.+
Radio Trifield 65
Subwoofer crossover frequency
The G68 Digital Surround Controller allows the crossover frequency
for any subwoofers which you have to be adjusted between 30 and
150Hz. The crossover can be set independently for Music, Logic,
and 5.1 Movie layouts. The default is the THX standard of 80Hz.
To adjust the subwoofer crossover frequency
• Select a source, then display the Sine/Sub/Sens controls as
described above.
• Press Xovr- or Xovr+ to decrease or increase the crossover
frequency.
The display shows the current crossover frequency:
Sine -Xover+ -Sens.+
CD Xover 85Hz
For THX loudspeaker systems you should not adjust these settings;
they should be left at 80Hz. 80Hz is also the recommended setting
for all movie listening. You may prefer, however, to lower the
crossover frequency for music if the main speakers have good bass
handling down to, say, 50Hz.
Sinewave sweep test
The G68 includes a sinewave signal test, to help you set the
subwoofer crossover frequencies, or check for room resonances.
Warning: This test is very loud. Very loud low-frequency
signals may damage the speakers.
To use the sinewave sweep test
• Select a source, then display the Sine/Sub/Sens controls as
described above.
• Press Sine to turn on the sinewave signal.
The display shows:
Chan утф цхъ Exit Sound
CD Sine 80.0Hz
Using the Sine/Sub/Sens controls
G Series DSP 40 31/10/03, 4:24:29 pm