6 diagnostics, Diagnostics – MITSUBISHI ELECTRIC FX0N-232ADP User Manual
Page 9
DIAGNOSTICS
●
If sending and receiving using these programs is
successful, it is considered that the operation failure
was due to sequence program or communication
protocol error.
●
Program when receiving
* Write the data to be sent to D 0 to D 19 before operating.
●
If not operating normally when using these programs,
eliminate the cause using the flow diagrams shown
following.
●
Set the communication format according
to the external device to be used.
●
If data transfer does not perform correctly when using
the 232ADP, check the operation using the following
programs.
●
Program when sending
[
]
[
]
●
Set the communication format according
to the external device to be used.
●
Header and terminator are not attached.
Receive completion reset
[
[
]
[
]
[
]
[
]
Send request
[
]
[
]
]