MITSUBISHI ELECTRIC FX0N-232ADP - Manual (Page 6)

PROGRAM EXAMPLES
Printer
• Receive data
FX 0N series sequencer
Send
• Send data
● The communication format of the serial printer is as follows.
● Connecting 232ADP and a printer,and printing out the data sent from the PC.
Common pin out for printer communication
X000,ON
X001,ON
Power on
RS instruction
drive
Data send
Turn on the power of the PC and
printer, check the printer is on line
and switch the PC to RUN.
Turn on X000, and drive RS
instruction.
Every time X001 is turned on,
the contents of D200 to D210
are sent to the printer, and
"test line" is printed.
● In this example, CR (H000D) and LF
(H000A) are written at the end of the
message.The printer moves down
one line for each message.
CR: Carriage Return
LF: Line Feed
Note:It may be necessary to set the
DIP switches of your printer.
Check your printer manual for how to
configure the serial communications.
Sequence program
Operation
Data length 8 bit
Parity Even
Stop bit 2 bit
Baud rate 2400bps