Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle - Manual (Page 21)

OM-884 Page 17
2-14. Installing Optional Reel-Type Wire
ST-161 000-A / ST-152 463 / Ref. ST-157 999-A
1 Retaining Ring
2 Lock
3 Spanner Nut
4 Wire Retainer
5 Welding Wire
6 Wire Reel
7 Hub
Remove retaining ring. Pull lock
and turn. Remove spanner nut, wire
retainer, and wire reel from hub.
To install wire lay wire reel on flat
surface and install wire as shown.
Tighten spanner nut until lock is in
position over hole in wire retainer.
Pull lock and turn to insert locking
pin into wire retainer.
Slide wire reel assembly onto hub.
Turn assembly until hub pin is
seated in hole in reel. Reinstall
retaining ring.
3
4
5
6
Wire Installation
1 3 4
5
6
7
Unlocked
2
SECTION 3 – OPERATION
3-1. Safety Equipment
sb3.1 1/94
Wear the following while welding:
1 Dry, Insulating Gloves
2 Safety Glasses With Side
Shields
3 Welding Helmet With Correct
Shade Of Filter (See ANSI
Z49.1)
1 2 3