Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle - Manual (Page 20)

OM-884 Page 16
2-12. Hub Assembly Installation
ST-126 870-A
1 Spool Support
2 Hub Support Shaft
3 Retaining Ring
4 Hub Assembly
5 Brake Washer
6 Fiber Washer
7 Hex Nut
Install hub assembly as shown.
Tighten hex nut until a slight drag is
felt while turning hub.
Tools Needed:
9/16 in
1
2
3
4
5
6
7
2-13. Installing Spool-Type Wire And Adjusting Hub Tension
ST-161 001
1 Retaining Ring
2 Wire Spool
3 Hole In Spool
4 Hub
Remove retaining ring and slide
spool onto hub. Turn spool until hub
pin fits hole in spool. Reinstall re-
taining ring.
5 Tension Adjustment Nut
Grasp spool in one hand and turn
while using a wrench to adjust hex
nut. When a slight force is needed
to turn spool, tension is set.
Tools Needed:
9/16 in
1
2
3
4
5