Multi-Tech Systems BA-Series - Manual (Page 88)

88
MultiModemBA User Guide
Command Values Description
DsNd s = phone # Store telephone number. To store, phone d = 0 thru
9 number ”s“ is entered and followed by N and then
Directory Number “d.”
&Dn n = 0 thru 3 &D0 DTR is ignored
&D1 means modem returns to command mode.
* &D2 lets modem react to DTR normally.
&D3 causes modem to reset to modem default
parameters.
%DFn n = 0 or 1 * %DF0 Line Probe Data in Graph Format.
%DF1 Line Probe Data in Table Format.
%DPn n = 0 or 1 * %DP0 do not read Line Probe Information from DSP
during handshaking.
%DP1 read Line Probe Information from DSP during
handshaking.
$Dn n = 0 or 1 * $D0 disables DTR Dialing.
$D1 enables DTR Dialing.
En n = 0 or 1 E0 means do not echo Command Mode Character.
* E1 means do echo Command Mode characters.
&En n = 0 thru 15 &E0 means no error correction.
* &E1 means V.42 Auto-reliable Mode.
&E2 means V.42 Reliable Mode.
&E3 means no modem-initiated flow control.
* &E4 means CTS modem-initiated flow control.
&E5 means Xon/Xoff modem-initiated flow control.
* &E6 means Xon/Xoff not passed through.
&E7 means Xon/Xoff passed through.
* &E8 means Enq/Ack pacing off.
&E9 means Enq/Ack pacing on.
* &E10 means Normal Mode flow control off.
&E11 means Normal Mode flow control on.
&E12 means Pacing off.
* &E13 means Pacing on.
&E14 means data compression disabled.
* &E15 means data compression enabled.
$EBn n = 0 or 1 * $EB0 enables 10 bit mode.
$EB1 enables 11 bit mode.
%En n=0 thru 5 % E0 = Modem Won’t Escape.
* % E1 = +++ Method (default setting).
% E2 = Break Method.
% E3 = Either +++ or Break Method.
% E4 = No "OK" Response to +++
% E5 = "OK" Response to +++
#Fn n = 0 thru 2 #F0 means no fallback when on-line.
#F1 means fallbackwhen on-line (increments of
2400 bps).
* #F2 means fallback to 4800 bps/fall forward if line
improves (increments of 2400 bps).