beautypg.com

Installation and initial setup – Marshall electronic ORCHID OR-841-HDSDI User Manual

Page 5

background image

Installation and Initial Setup

Unpacking

Carefully unpack the OR-841-HDSDI monitor and verify that the following items are included:

• OR-841-HDSDI Monitor

• 12V 4A XLR Power Supply with 4-Pin Female XLR Connector

• Operating Instructions

Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage,

immediately call Marshall Electronics Customer Service at (800) 800-6608. If you are not located within the

continental United States, call +1 (310) 333-0606.

Mounting

The OR-841-HDSDI is designed as a tabletop camera assist or tri-pod/camera-top monitor. It comes complete

with tabletop stand, easy-to-carry handle on top, and is equipped with both ¼-20 and 3/8” threaded mounts on

top and bottom. The included handle and stand may be removed for access to the threaded mounts.

There is an optional OR-8RK rack mount kit for mounting two OR-841-HDSDI units side by side in a standard

19” rack. When used in this configuration, the Dual OR-841-HDSDI units occupy 5 RU and have a +/- 40° Tilt.

Other optional accessories include the OR-8HO Custom Hood for daylight viewing and the OR-8HA optional

side mount handle. One handle may be mounted on each side of the OR-841 for easy carrying during a wireless

camera shoot.

Connections and Power-On

Plug the power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the 4-pin female XLR

connector to the back of the monitor. The monitor will draw no more than 4.0 Amps at 12 Volts in operation

(24 Watts).

Connect the required cables for video signal input and output (Power must be applied to the OR-841-HDSDI for

the active loop-through outputs to be activated). All BNC connectors are rated at 75Ω.

5

Optional Accessories for OR-841

OR-8HA

Side Handle

OR-8HO

Hood

OR-8RK

Rack Mount Kit (Mounts two units side-by-side)