Marshall electronic ORCHID OR-841-HDSDI User Manual

Page 21

■ TimeCode

Selects among to following options: OFF / LTC / VITC1 / VITC2. In the most cases, the value of LTC and

VITC1 will be identical to each other.

■ Power Save

• When enabled, the monitor will go to sleep after a predefined time has passed when loss of picture occurs.

• When a valid video format is detected, the monitor will wake up from the sleep state.

• Pressing any front panel keys will wake up the monitor.

• In the sleep state, all lights (including the backlight and front key indicators) are turned off.

• Any change in parallel remote status will wake up the monitor.

• Tally status is not affected by sleep mode.

■ Key Lock

When it is locked, user cannot use front panel keys except for accessing the menu.

■ Reset to MFG Default

• This will Restore all configuration values and functions to the factory preset state.

• This will not change Model Name, Serial Number, or White Balance Data.

• Requires Confirm action by selecting Confirm again.

(Select Reset -> RotoMenu control -> Select Confirm -> Press RotoMenu control)

• Resetting default will not effect backed up data.

■ Backup User Configuration

• This command backs up all user information to secondary EEPROM (User settings)

• Requires Confirm action by selecting Confirm again.

(Select Backup -> Press RotoMenu control -> Select Confirm -> Press RotoMenu control)

■ Restore User Configuration

• This will Restore all configuration values and functions to the factory preset state.

• This will not change Model Name, Serial Number, or White Balance Data.

• Requires Confirm action by selecting Confirm again. (Select Reset -> Press the RotoMenu control ->

Select Confirm -> Press Enter the ROTO-Menu control)

• Resetting default will not effect backed up data.

■ Backup User Configuration

• This command backs up all user information to secondary EEPROM (User settings)

• Requires Confirm action by selecting Confirm again. (Select Backup -> Press the RotoMenu control ->

Select Confirm -> Press Enter the RotoMenu control)