beautypg.com

1dca-125usj — generator shut-down procedure – Multiquip MQ Power 60 Hz Generator DCA125USJ User Manual

Page 39

background image

DCA-125USJ — OPERATION AND PARTS MANUAL — REV. #2 (01/27/11) — PAGE 39

1

DCA-125USJ — GENERATOR SHUT-DOWN PROCEDURE

Normal Shutdown Procedure

To shutdown the generator use the following procedure:

1. Place both the MAIN, GFCI and LOAD circuit breakers

as shown in Figure 38 to the OFF position.

3. Let the engine cool by running it at low speed for 3-5

minutes with no load applied.

4. Place the

MPEC Control Switch (Figure 55) to the

OFF/RESET position.

Figure 55. MPEC Control Switch (Off/Reset)

5. Verify that the

all status LED’s on the MPEC display

are OFF (not lit).

6. Remove all loads from the generator.

7. Inspect entire generator for any damage or loosening of

components that may have occured during operation.

Emergency Shutdown Procedure

1. To shut-down the engine in the event of an emergency,

switch the

MAIN, GFCI and LOAD (Figure 38) circuit

breakers to OFF position.

2. Place the

MPEC Control Switch switch (Figure 55) to

the OFF/RESET position.

NEVER stop the engine suddenly except in an emergency.

WARNING - SHUTTING DOWN THE GENERATOR

This manual is related to the following products: