Multi-Tech Systems MTSGSM - Manual (Page 37)

Chapter 5 - AT Commands, S-Registers, and Error Codes
MTSGSM 37
Defined values Meaning
Location value of message to be read
+CMGL List messages
Syntax AT+CMGL[=| used to list messages
The response is +CMGL: ,,,
AT+CMGL=? for a list of supported .
The response is +CMGL: (list of supported )
Error codes is returned as +CMS ERROR: :
Description The AT+CMGL command list messages from the preferred message storage. Entire
data units (PDU) is returned.
Defined values Meaning
4
All messages
+CGSN Request product serial number identification
Syntax AT+CGSN used to get phone serial number info. The response is +CGSN: .
Error codes is returned as +CME ERROR: :
Description The AT+CGSN command returns one ore more lines of information text determined
by the phone manufacturer intended to identify the individual phone..
Defined values Meaning
Information text determined by the phone manufacturer.
+CHUP Hangup call
Syntax AT+CHUP used hangup GSM call
Description The AT+CHUP command causes hangup of the current GSM call.
+CMGR Read message
Syntax AT+CMGR= used to read a message
The response is +CMGR: ,
Error codes is returned as +CMS ERROR: :
Description The AT+CMGR command reads a message with location value from
preferred message storage to the TE. Status of the message and the entire
message data unit is returned.
Defined values Meaning
Location value of message to be read
+CMGS Send message
Syntax AT+CMGS= PDU is given/ESC> used to send messages
Error codes is returned as +CMS ERROR: :
Description The AT+CMGS command sends a message to the network (SMS-SUBMIT).
Message reference value is returned to the TE on successful message
delivery. The TA shall send a four character sequence <
CR>
(in hex 0xd 0xa 0x3e 0x20) after the command line is terminated with
; after that PDU can be given. (in hex 0x1a) must be used to indicate
the ending of PDU
Defined values Meaning
Must indicate the number of octets coded in the TP layer data unit to be given.