MITSUBISHI ELECTRIC WS-65908 - Manual (Page 40)

40 40
Part III: Setup
C
o
n
v
e
rg
e
n
c
e
Advanced Menu: Convergence
Convergence Menu
(Figure 2)
Convergence aligns the entire screen at
once. Select either Red Convergence or
Blue Convergence to begin alignment. To
align 64 individual points, see Advanced
Convergence, page 41.
Convergence
(Figure 1)
Your Mitsubishi TV has three picture tubes
which are aligned to properly converge the
projected light beams on the screen. Each
picture tube projects a single color of red,
blue or green. During production, your
TV was carefully adjusted to properly align
these colors. As a special feature, you have
the ability to adjust the red and blue light
beams in reference to the xed gr een l ight
beam. This process is called convergence.
Convergence Screen
(Figure 3)
When the Red and Blue crosshairs are prop-
erly converged, the center-screen crosshairs
will appear white. You can use , , ,
or to move the Red and Blue crosshairs.
Press VIDEO to switch between Red and
Blue. Press AUDIO for the Advanced Con-
vergence screen, and see Advanced Conver-
gence, page 41, for instructions.
Reset Factory Defaults
(Figure 2)
This allows you to reset the convergence to
the factory settings. The message “Conver-
gence completed” will be displayed when
the factory defaults have been restored.
Figure 1. Convergence selection in the Advanced menu
Figure 2. Convergence menu
Red
Press ADJUST to converge the lines
Press VIDEO to switch to Blue
Press MENU to go back
Press CANCEL to delete changes
Press AUDIO Advanced Convergence
Figure 3. Convergence screen