Motion Computing 002-15-0010 User Manual
Page 3
Motion MCW with MediaWave Computer
– Installation and Assembly Procedure
iii
Document No. 002-15-0010
Motion Proprietary & Confidential
Copyright © 2009 Motion Computing, Inc. as an unpublished work
7.
ASSEMBLE THE MOUNTING PLATE AND BATTERY GAUGE ......................................................... 13
7.1
P
LACE THE
M
OUNTING PLATE WITH THE BACK SIDE FACING UP
,
AND SET THE
B
ATTERY
G
AUGE PLATE OVER
THE FIXED MOUNT SCREWS
. ........................................................................................................................... 14
7.2
A
TTACH THE
B
ATTERY
G
AUGE HOUSING TO THE
M
OUNTING PLATE
. ............................................................ 14
7.3
T
URN OVER THE
M
OUNTING PLATE ASSEMBLY
,
REMOVE THE ADHESIVE COVER PAPER FROM THE BACK OF
THE
B
ATTERY
G
AUGE
,
AND ADHERE THE
B
ATTERY
G
AUGE TO THE
M
OUNTING
P
LATE ASSEMBLY
. .............. 15
8.
PLUG THE RJ45 BATTERY GAUGE CABLE INTO THE JACK, THROUGH THE HOLE IN THE
BACK OF THE BATTERY GAUGE HOUSING. ........................................................................................ 16
9.
ATTACH THE BATTERY GAUGE MOUNT PLATE TO THE BACK CPU VESA MOUNT PLATE17
10.
PLUG IN AND SECURE MONITOR CABLES ........................................................................................... 18
11.
PLUG IN AND SECURE COMPUTER CABLES ....................................................................................... 18
12.
DRESS THE CABLES AT THE MONITOR AND CPU USING CORRUGATED CABLE WRAP,
SECURING WITH CABLE TIES. ................................................................................................................. 19
13.
PULL THE EXCESS CABLE LENGTH TO THE BOTTOM OF THE COLUMN ................................. 19
14.
DRESS THE CABLES AT THE BOTTOM OF THE COLUMN USING CORRUGATED CABLE
WRAP, SECURING WITH CABLE TIES, AND PULLING THE EXCESS CABLE LENGTH INTO
THE SHEET METAL BASE. ......................................................................................................................... 20
15.
INSTALL BATTERIES WITH TERMINAL POINTING OUT. IF THE BATTERIES ARE TURNED
IN, THE THERMAL SENSORS WILL READ INCORRECTLY. ............................................................ 21
16.
THE UNPAINTED SIDE OF THE THERMAL SENSOR MUST BE IN CONTACT WITH THE
BATTERY POST. ............................................................................................................................................ 22
17.
MAKE SURE BATTERY CONNECTIONS ARE TIGHT ON BOTH BATTERIES .............................. 22
18.
REINSTALL THE SHROUD AND COLUMN TOP PLATE ..................................................................... 23