Philips Magnavox ZV450MWB - Manual (Page 14)

14 EN 14 EN
RF MODULATOR CONNECTION
rear of your
RF modulator
AUDIO IN ANT. IN TO TV
L R
CHANNEL
4 3
VIDEO IN
Set channel 3 or 4
rear of this unit
DVD
DIGITAL AUDIO OUT AUDIO OUT S-VIDEO
OUT IN
COAXIAL
L
R
L Y
P B /C B
P R /C R
R
L
R
OUT
IN
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
COMPONENT VIDEO OUT
DVD/VCR
ANTENNA
OUT
IN
ANTENNA
IN
L
R
S-VIDEO IN --- AUDIO --- OUT
IN --- VIDEO --- OUT
DVD/VCR
VHF / UHF
antenna
cable TV
company
RF coaxial cable
or
RF coaxial cable RCA audio
cable
RCA video
cable
rear of your TV
ANT. IN
If your TV has antenna in jack only, it is still possible to connect this unit to your TV by using a stereo audio/video RF
modulator. In this case, follow the instructions below.
1) Disconnect the power cords of the devices from the AC outlet.
2) Make the connection as illustrated below.
3) Set your RF modulator’s channel 3/4 switch to either 3 or 4, whichever the TV channel is least used in your area.
If your RF modulator has a modulator/antenna switch, set it according to the manual supplied with the RF
modulator.
4) Plug in the power cords of the devices to the AC outlet.
5) Turn on your TV and choose the same channel as you set the RF modulator’s channel 3/4 switch to.
For more details, follow the manual supplied with the RF modulator.
Note
• The quality of picture may become poor if this unit is connected to an RF modulator.
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
E9C80UD.indd 14 E9C80UD.indd 14 2006/12/19 14:03:05 2006/12/19 14:03:05