Philips Magnavox ZV450MWB - Manual (Page 39)

39 EN 39 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
VCR Functions
Others
Español
TIMER RECORDING
Checking, canceling, or correcting the timer
programming information If the timer program did not complete correctly,
the error number appears in the timer pro-
gramming list.
1) Press [TIMER SET].
2) Press [TIMER].
3) Check the information on the list you will need.
Timer Programming VCR DVD
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
1. JAN/01 12:57AM 1:57PM HQ DVD 8
Date Start End CH Mode DVD
VCR
4) To clear the timer programming:
Use [K / L] to select the program, then press
[CLEAR].
To correct the timer programming:
Use [K / L] to select your desired program, then
press [OK].
Next, correct the timer programming by using
[K / L / { / B]. Finally, press [OK] again.
5) Press [TIMER] to exit.
6) Press [TIMER SET] to return to the timer standby
mode.
Timer Programming VCR DVD
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
JAN/01 12:57AM 1:57PM E22 DVD 8
Date Start End CH Mode DVD
VCR
*
Press [CLEAR] to erase the selected program.
Each error number means:
E1-22
E37-39 Recording error other
than below E41 Power failed
E24 Unrecordable disc E42 No disc when
recording
E25-26 Copy prohibited
program
E43 Already 49 titles
recorded
E29 Disc protected E44 Already 254 chapters
recorded
E30 Disc full E45 Copy prohibited
program
E35 PCA full E46 It is impossible to
record additionally
on a disc recorded
by other units when
setting “Replace Disc
Menu” to “OFF”.
E36 Already finalized
video format disc
E40 Some portion has
not been recorded
because of program
overlapping.
Recording did not
start at the start time.
• E23, E27, E28, E31, E32, E33 and E34 are not displayed.
• A program with the error number is grayed and
asterisked in the timer programming list.
• Once the timer programming list with error line(s) is
displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be
cleared.
Press [STOP C] to stop the disc recording or
[STOP C/EJECT A] to stop the cassette tape recording
on the front panel of the unit.
[STOP C] on the remote control is not effective.
Note
• Press [TIMER] to check the timer recording in
progress.
When the timer recording is proceeding, that
program will be highlighted with red. In this case,
you cannot select any other program.
To stop the timer recording in process
E9C80UD.indd 39 E9C80UD.indd 39 2006/12/19 14:03:15 2006/12/19 14:03:15