Installing remote controls – Marmitek TOTALGUARD User Manual

Page 12

3. Installing remote controls

3.1 Key Chain Remote Control KR21

1. CONTROLE INDICATOR

Lights up when the remote control transmits radio signals when
pressing the buttons. If the indicator light is not very bright, the
batteries should be replaced.

2. ARM

Switches on the alarm in Arm Away mode (all sensors activated).

3. DISARM

Switches off the security system.

4. LIGHTS ON

Switches on your light modules (7.5).

5. LIGHTS OFF

Switches off your light modules (7.5).

8. PANIC

If the (red) buttons 7 and 8 are pressed together, the panic alarm is
activated (6.2).

9. BATTERY COMPARTMENT

The battery compartment can be found in the remote control.

3.1.1 Using the Key Chain Remote Control
1. BATTERIES

A new KR21 contains fully charged batteries.

2. ACTIVATING THE KR21.

Keep the ARM button on your remote control pressed for 4 seconds. Release the button. The remote control has now
chosen a unique code, which can be registered with your console.

☺ When pressing the ARM button the LED should flash quickly a few times. When the LED lights up and stays lit, you need to

reactivate the KR21

3.1.2 Registering the Key Chain Remote Control
1. To access the menu, press the menu

or menu

button. The display will now read ‘ENTER PIN’.

2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear

on the display.

3. When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.
4. Press OK. The display now reads ‘INSTALL ZONE’.
5. Press the ARM button on your key chain remote control. The console will beep to confirm. The display will read ‘RMOT 1 SET’.

☺ If you have more than 1 remote control installed, it will read e.g. RMOT 2 SET, RMOT 3 SET, … RMOT 16 SET. You can register

up to 16 remote controls.

6. Repeat step 5 for every remote control you wish to register.
7. Press CLEAR to go back to the main menu. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2

for No. If you choose Yes, you will quit the menu. If you choose No, you go back to the main menu.

☺ You can also remove remote controls from the menu, e.g. when you have lost a remote control. This method is described in 8.2.

☺ Read chapter 12 for information on replacing the batteries..

BASIC OPTIONS

MARMITEK

20071_20070228_UG_SC9000_EN 08-03-2007 10:07 Pagina 12