Getting started – Philips Magnavox mdv436 User Manual

Page 17

English

Getting Started

Step 1 : Inserting Batteries

Open the battery compartment.

Insert two batteries type R03 or AAA,

following the indications (+ –) inside the
compartment.

Close the cover.

CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.

Using the remote control to
operate the system

Aim the remote control directly at the

remote sensor (IR) on the front panel.

Do not put any objects between the

remote control and the DVD player
while operating the DVD player.

Step 2 : Finding your viewing
channel

Press STANDBY-ON 2 on the DVD

player to turn it on.

Turn on the TV and set it to the correct

video-in channel. You should see the blue
DVD background screen.

Usually these channel are between the

lowest and highest channels and may
be called FRONT, A/V IN, VIDEO.
See your TV’s manual for more
details.

Or, you may go to channel 1 on your

TV, then press the Channel down
button repeatedly until you see the
Video In channel.

Or, the TV remote control may have

a button or switch that chooses
different video modes.

Or, set the TV to channel 3 or 4 if

you are using an RF modulator.

If you are using external equipment, (e.g.

audio system or receiver), turn it on and
select the appropriate input source for
the DVD player output. Refer to the
equipment user’s manual for detail.

01-37 MDV435_436_37_eng_RC2.indd 17

2006-04-27 5:08:05 PM