Grizzly G0624 - Manual (Page 14)

-12-
G0624 10" Benchtop Lathe
Assembly
To install the tool rest:
1. Turn the release lever on the tool rest base
so it does not interfere with assembly.
2. Thread the tool rest lock handles into the tool
rest base ( Figure 6) until the threaded ends
of the handles are flush with the inside of the
shaft.
Figure 6. Tool rest lock handles installed onto
tool rest base.
3. Insert the tool rest into the shaft and turn the
handles to lock it as shown in Figure 7.
Figure 7. Tool rest installed.
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, and 2)
the safety paddle switch works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 24. If you still cannot
remedy a problem, contact our Tech Support at
(570) 546-9663 for assistance.
To test run the machine:
1. Make sure that you have read the safety
instructions at the beginning of this manual
and that the machine is setup properly.
2. Connect the machine to the power source.
3. Flip the paddle switch up to turn the machine
ON. Make sure that your hand stays poised
over the switch in case you need to quickly
turn the machine
OFF.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
4. Turn the machine OFF.
5. Remove the safety key and attempt to turn
the machine ON.
—If the machine starts, stop it. The switch
disabling feature is not working. This safety
feature must work properly before proceed-
ing. Call Tech Support for help.
—If the machine does not start, the switch
disabling feature is working.
Release Lever
Tool Rest
Base
4. Install the optional bed extension, Model
G0625 ( Page 21). Refer to the instruction
sheet included with the bed extension.
Lock Handle
Lock
Handle