Graco Forward Facing Child Restraint - Manual (Page 32)

32
8.2 Airplane Use
8.1 Storing LATCH and Tether
8.0 Additional Information
1. For ease of storing, extend
LATCH to its maximum
length.
2. Locate the storage bar on
back of child restraint
➊
.
3. Fasten LATCH connectors
to storage bar as shown.
4. After fastening to storage
bar, pull on adjustment belt
to make sure LATCH is
securely fastened.
5. Fasten tether clip to storage
bar and tighten strap.
6. LATCH and tether storage
should look like this when
complete
➊
.
➊
LATCH
Storage bar
Tether
Storage bar
This restraint is certified for use in Motor Vehicles and
Aircraft
Important points to remember
1. Airlines have some restrictions about the use of
child restraints.
2. Install your child restraint on an airplane in the
same way it is installed in an automobile with a lap
belt using recline position 2. (see Section 7.1, With a
Vehicle Lap Only Belt, pp. 22-23).
3. Check that the airplane seat belt holds the child
restraint securely in place at all times.