Graco Forward Facing Child Restraint - Manual (Page 28)

28
1. Remove both LATCH
connectors and the tether
connector from the storage
bars and extend LATCH to
its maximum length for
ease of installation.
2. Place the child restraint
firmly against the back of a
forward-facing vehicle seat
with LATCH lower anchors.
3. Hook LATCH Connectors
to vehicle lower anchors
➊
.
Pull firmly on Connectors
to be sure they are attached
➋
.
Belt must lay flat and
not be twisted.
4. Tighten LATCH by
pushing down hard on
child restraint and pulling
the adjustment belt
➌
.
5. NEVER put two LATCH
connectors on one vehicle
LATCH anchor unless
specifically allowed by the
manufacturer
➍
.
➋
gra co ba by. com
➌
➍
gra co ba by. com
➊