Grizzly Disc G0724 - Manual (Page 18)

-16-
Model g0724 (Mfg. since 09/11)
SECtION 4: OpERAtIONS
Operation Overview
to complete a typical operation, the operator
does the following:
1. Examines the workpiece to make sure it is
suitable for sanding.
2. adjusts the table tilt and miter gauge, if nec-
essary, to the correct angle for sanding.
3. puts on safety glasses and a respirator, and
locates push blocks if needed.
4. starts the sander.
5. Feeds the workpiece along the disc, firmly
holding it against the table and gauge while
keeping hands and fingers away.
6. stops the machine.
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
Damage to your eyes and lungs could result
from using this machine without proper pro-
tective gear. Always wear safety glasses and
a respirator when operating this machine.
to reduce the risk of
serious injury when using
this machine, read and
understand this entire
manual before operating.
NOTICE
If you have never used this type of machine
or equipment before, WE StRONGLy REC-
OMMEND that you read books, review
industry trade magazines, or get formal
training before beginning any projects.
Regardless of the content in this section,
Grizzly Industrial will not be held liable for
accidents caused by lack of training.