Grandstream Networks HT-286 User Manual
Page 16
Grandstream Networks, Inc.
HT–286 User Manual
Page 16 of 28
Firmware 1.1.0.31
Last Updated: 1/2009
Only an administrator can access the “ADVANCED SETTING” configuration page.
NOTE: If you cannot log into the configuration page by using default password, please check with the
VoIP service provider. The service provider may have provisioned and configured the device for you. The
Basic Configuration Page is the first web GUI the user will see.
T
ABLE
8:
HT–286
B
ASIC
C
ONFIGURATION
S
ETTINGS
D
EFINITIONS
End User Password
Password to access the Web Configuration Menu. This field is case
sensitive with a maximum length of 25 characters.
Web Port
By default, HTTP uses port 80. This field is for customizable web port.
IP Address
There are two modes to operate the HT–286:
DHCP mode: all the field values for the Static IP mode are not used (even
though they are still saved in the Flash memory.) The HT–286 acquires its
IP address from the first DHCP server it discovers from the LAN it is
connected.
Using the PPPoE feature: set the PPPoE account settings. The HT–286
will establish a PPPoE session if any of the PPPoE fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router
IP address, DNS Server 1 (primary), DNS Server 2 (secondary) fields.
These fields are set to zero by default.
DHCP hostname
This option specifies the name of the client. This field is optional but may
be required by some Internet Service Providers. Default is blank.
DHCP domain
This option specifies the domain name that client should use when
resolving hostnames via the Domain Name System. Default is blank.
DHCP vendor class ID
Used by clients and servers to exchange vendor-specific information.
Default is blank.
PPPoE account ID
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point
to Point Protocol over Ethernet) connection.
PPPoE password
PPPoE account password.
PPPoE Service Name
This field is optional. If your ISP uses a service name for the PPPoE
connection, enter the service name here. Default is blank.
Time Zone
Controls how the date/time displays according to the specified time zone.