Happens in each cycle, Temperature sensor system – GE Monogram ZBD3000 User Manual
Page 12
![background image](/manuals/112694/12/background.png)
(continued)
happens in each cycle
●
You’ll hear occasional
sounds:
—Soft food disposer shredding action.
—Drain valve opening to pump water out.
—Detergent cup opening.
●
The motor stops during drying.
●
Water vapor comes through the vent by the door latch
during drying and when water is being pumped out.
Fills
6
7
6
7
6
5
6
5
1
Cycles
NORMAL WASH
SHORT WASH
SHORT WASH
SHORT WASH
CHINA CRYSTAL
CHINA CRYSTAL
RINSE & HOLD
Water
I
Gallons
Soil
11
10
10
8
Soil
11
9
9
7
2
-ox.)
Light
Soil
9
9
8
6
Time
Soil
55
35
Soil
31
38
5
Light
Soil
57*
49*
27
35
*Unextended times. These
times
be increased to 15 minutes if
for your dishwasher to heat the water to
proper temperature for
WASH
BOOST is selected, time-maybe extended up to 30 minutes total,
during
or NORMAL cycles.
Drying Cycle Options:
HEATED DRY on. Available on all wash cycles except RINSE& HOLD. Add 30 minutes to wash cycle time.
HEATED DRY off (Energy Saver Drying). Drying heater is turned off. Dishes dry naturally.
Temperature Sensor System
To get dishes clean and dry you need hot water. To help you get water of the proper temperature, your dishwasher
has a water heating feature that automatically senses the temperature of the water in the wash cycle and heats it, if
necessary, to the proper temperature. This water heating feature may allow you to turn down your household water
heater and save energy if you’re willing to let the dishwasher run a little longer while it heats water to the proper
temperature. For good washing and drying, the entering water must be at least
To prevent dish damage, inlet
water should not exceed
12