Grizzly G0574 - Manual (Page 21)

G1140 Edge Sander -17-
Platen Tilt
Figure 23. Platen lock bolt.
Figure 24. Platen tilted over 90 ˚.
1. Loosen the lock bolt shown in Figure 23.
2. Carefully tilt the platen assembly over.
Figure 24.
3. After returning the platen assembly back to
its upright position, retighten the lock bolt
depicted in
Figure 23.
Belt Tension
Figure 25. Belt tension mechanism.
Belt tension is preset at the factory and usually
requires no adjustment. If the need to increase
the tension should occur, unthread the retaining
nut at the end of the idler roller mounting shaft.
See Figure 25. Do not unthread the nut more
than 1 ⁄
2
its length. If tension problems persist, call
the service center for further help.
Operating this equipment has the potential
to propel debris into the air which can
cause eye injury. Always wear safety glass-
es or goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glass-
es you wear meet the appropriate stan-
dards of the American National Standards
Institute (ANSI).