Grandstream Networks Grandstream GXP-1200 - Manual (Page 31)

Grandstream Networks, Inc. GXP User Manual Page 31 of 39
Firmware 1.1.6.46 Last Updated: 03/2008
Call Progress
Tones Using these settings, users can configure ring or tone frequencies based on parameters
from local telecom. By default, they are set to North American standard.
Frequencies should be configured with known values to avoid uncomfortable high pitch
sounds.
Syntax
: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order
to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern. Up to three cadences are supported.
Intercom User
ID: This field is used to configure the Intercom key in the phone. For GXP2010 and
GXP2020 only
If the phone is working with a GS GXE502X IP-PBX it can be configured in the following
manner:
• To page an extension : [intercom feature code]+[*]+[extension number]
• To page a group : [paging group feature code]+[*]+[group extension]
Disable Call
Waiting Default is No. If set to Yes, the call waiting feature will be disabled.
Disable Call
Waiting Tone Default is No. If set to Yes, the call waiting tone will be disabled.
Disable Direct
IP Calls Default is No. If set to Yes, direct IP calls will be disabled
Use Quick IP
Call Mode Dial an IP address under the same LAN/VPN segment by entering the last octet in the IP
address.
In the Advanced Settings page there is an option “Use Quick IP-call mode”. Default
setting is No. When set to YES, and #XXX is dialed, where X is 0-9 and XXX <=255,
phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the
local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call Mode
for details.
Disable
Conference Default is No. If set to Yes, conference will be disabled.
Lock keypad
update If set to “Yes”, the configuration changes via keypad are disabled.
Enable MPK
Sending DTMF Default is No. If set to “Yes”, Muti-Purpose keys can be sent as DTMF.
For GXP2020/2010/2000.
Disable DND Default is No. If set to “Yes”, the “DND” button on keypad will be disabled. For GXP2000,
MUTE/DEL button functions as DND button when pressed while phone is idle.
Disable
Transfer Default is No. If set to Yes, transfer will be disabled.
Display CID
instead of Name If set to “Yes”, CID will be displayed in the screen instead of Name. Default is ”No”. For
GXP280 only.