Grizzly G0601 - Manual (Page 25)

Model g0442/g0601 (Mfg since 3/12)
-23-
10. Lift the assembly upright and rotate it so the
inlet/outlet directions are suitable for your
shop.
11. Lift the motor/blower housing assembly with
a forklift and attach the intake cylinder to the
bottom of the housing, as shown
figure 17,
using (4) 5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts and (4) 5 ⁄
16
"
flat washers.
note: Because this part of the dust collec-
tor is not accessible after the assembly is
complete, consider using Medium Strength
Blue Thread Locker (Grizzly Model T21854)
on the bolts that secure the intake cylinder
to the motor/blower housing assembly to
ensure that the fasteners won't come loose
with vibration.
figure 17. intake cylinder attached to the bottom
of motor/blower housing.
x 4
13. using two punches or phillips screwdriv-
ers, align the mounting holes, as shown in
figure 18, and lower the assembly onto the
intake barrel.
figure 18. Aligning the mounting holes.
Barrel gasket
here
note: In the next step, when installing the two
bolts above the intake port, use duct tape on
the bottom of your wrench to hold the bolts
in place, as shown in
Figure 19. This will
enable you to start the bolts easier.
12. place the remaining barrel gasket on top of
the intake barrel, then carefully lower the
motor/blower housing assembly on top of it
approximately 1" away from the intake bar-
rel.
figure 19. using tape on wrench in tight spot.
tape