Grandstream Networks HT-496 - Manual (Page 9)

Grandstream Networks, Inc. HT–496 User Manual Page 9 of 33
Firmware 1.0.3.64 Last Updated: 1/2007
Basic Operations
G ET F AMILIAR WITH V OICE P ROMPT
HT–496 stores a voice prompt menu (Interactive Voice Response or IVR) for quick browsing and simple
configuration. The IVR menu and the LED button work with the FXS port 1 only.
Pick up the handset and press the button on the HT–496 or dial “***” to use the IVR menu,
T ABLE 4: HT–496 IVR Menu Definitions
Menu Voice Prompt Options
Main Menu “Enter a Menu Option” Press “*” for the next menu option
Press “#” to return to the main menu
Enter 01-06, 47, 86, 99 menu options
01 “DHCP Mode”,
“Static IP Mode”
Press “9” to toggle the selection
If using “Static IP Mode”, configure the IP address
information using menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information
comes from the DHCP server automatically after reboot.
02 “IP Address “ + IP address The current WAN IP address is announced
If using “Static IP Mode”, enter 12-digit new IP address.
03 “Subnet “ + IP address Same as menu 02
04 “Gateway “ + IP address Same as menu 02
05 “DNS Server “ + IP address Same as menu 02
07 Preferred Vocoder
Press “9” to move to the next selection in the list:
• PCM U / PCM A
• G.723
• G.729
• G.726
• iLBC
12 WAN Port Web Access
Press “9” to toggle between enable / disable
13 Firmware Server IP
Address
Shows current Firmware Server IP address. Enter 12-
digit new IP address.
14 Configuration Server IP
Address
Announces current Config Server Path IP address. Enter
12-digit new IP address.
15 Upgrade Protocol
Upgrade protocol for firmware and configuration update.
Press “9” to toggle between TFTP / HTTP
16 Firmware Version
Firmware version information.
17 Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among the
following three options:
- always check
- check when pre/suffix changes
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030