GE Monogram ZDIC150 - Manual (Page 9)

Installation Instructions
REVERSE THE DOOR SWING (cont.)
Reverse the hinges (all models):
• Remove the screws opposite the door hinges,
top and bottom. Set aside.
• Remove the two screws holding top hinge.
• Turn the hinge upside down, with the hinge pin
pointing up. Reinstall the hinge on the opposite
side at the bottom of the door.
• Remove the bottom hinge. Turn the hinge upside
down and install on the opposite side at the top.
• Remove the top hinge pin.
Prepare the stainless steel model door:
• Rotate the stainless steel door skin so that the
handle will be on the right side. Place the stainless
steel skin onto the door, keeping the edge
protectors in place.
• Reinstall the two screws in the top and bottom
of the door.
Reinstall the door (all models):
• Place plastic hinge sleeve on the bottom hinge
and position the door onto the pin.
• Place plastic hinge sleeve in the top hinge hole
on the door. Align the door on the bottom hinge
and replace top hinge pin.
•Reinstall handle with original screws.
Top Hinge
Bottom Hinge
REVERSE THE DOOR SWING (cont.)
Reinstall the door (all models) (cont.):
To reverse the door catch:
• Remove the plastic screws
from the op po site side
of the door.
• Remove the metal screws
from the mag net ic door
catch and reinstall on the
op po site side of the door.
• Install the plastic screw
into place on the op po site
side of the door.
9
INSTALL NAMEPLATE ON STAINLESS
STEEL MODELS
• Remove paper backing from the nameplate.
• Place nameplate onto the door.