Gefen GTB-HD-SIGGEN - Manual (Page 78)

72
HD PATTERN SIGNAL GENERATOR SOFTWARE
Writing EDID to a Sink
After an EDID has been read from another source or loaded from a fi le, the
EDID can be written to the sink connected to the output of the HD Pattern Signal
Generator.
1. Load an EDID into the HD Pattern Signal Generator by following the
instructions starting on page 65.
2. Click the WRITE button to write the EDID to the sink device.
Click to write the EDID
data to the sink device
WARNING:
Overwriting the EDID of a sink device may cause
unwanted results. Be sure to save a copy of the EDID. This will
allow the sink’s EDID to be restored if necessary. Also note that
not all device EDID data structures can be overwritten. If the sink
cannot be programmed with a new EDID, the WRITE process will
fail.