GIGABYTE GA-M68MT-S2P - Manual (Page 27)

- 27 - BIOS Setup
2-6 Integrated Peripherals
NV Serial-ATA Controller
Enables or disables the integrated SATA controller(s). You can select whether to enable all SATA control-
lers or only the first SATA controller. (Default: All Enabled)
Serial-ATA RAID Config
NV SATA RAID function
Enables or disables RAID for the integrated SATA 3Gb/s controllers. Enabled allows you to configure
RAID for individual SATA channel. (Default: Disabled)
NV SATA 1 Primary RAID
Enables or disables RAID for the first channel of the first integrated SATA 3Gb/s controller. This item is
configurable only when the NV SATA RAID function item is set to Enabled. (Default: Enabled)
NV SATA 1 Secondary RAID
Enables or disables RAID for the second channel of the first integrated SATA 3Gb/s controller. This item
is configurable only when the NV SATA RAID function item is set to Enabled. (Default: Enabled)
NV SATA 2 Primary RAID
Enables or disables RAID for the first channel of the second integrated SATA 3Gb/s controller. This item
is configurable only when the NV SATA RAID function item is set to Enabled. (Default: Enabled)
NV SATA 2 Secondary RAID
Enables or disables RAID for the second channel of the second integrated SATA 3Gb/s controller. This
item is configurable only when the NV SATA RAID function item is set to Enabled. (Default: Enabled)
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
NV Serial-ATA Controller [All Enabled]
 Serial-ATA RAID Config [Press Enter]
Onboard Audio Function [Auto]
On-Chip MAC Lan [Auto]
Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
USB Controllers [Enabled]
USB Legacy Function [Enabled]
USB Storage Function [Enabled]
 : Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level 
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Serial-ATA RAID Config
NV SATA RAID function [Disabled]
x NV SATA 1 Primary RAID Enabled
x NV SATA 1 Secondary RAID Enabled
x NV SATA 2 Primary RAID Enabled
x NV SATA 2 Secondary RAID Enabled
 : Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level 