Gardena Robotic Lawnmower R40Li - Manual (Page 9)

English - 9
1. INTRODUCTION AND SAFETY
• Full compatibility cannot be guaranteed between
the robotic lawnmower and other types of wireless
systems such as remote controls, radio
transmitters, hearing loops, buried electric animal
fencing or similar.
• Metal objects in the ground (e.g. reinforced
concrete or anti-mole nets) can result in a
stoppage. The metal objects can cause
interference with the loop signal which then can
lead to a stoppage.
Transport
The original packaging should be used when
transporting the robotic lawnmower over long
distances.
To safely move from or within the working area:
1. Press the STOP button to stop the robotic
lawnmower. If security is set to the medium or
high level (see
6.5 Security on page 49), the PIN
code has to be entered. The PIN code contains
four digits and is selected when you start the
robotic lawnmower for the first time. See
3.8 First
start-up and calibration on page 32.
2. Set the main switch in position 0 .
3. Carry the robotic lawnmower by the handle at the
rear under the robotic lawnmower. Carry the
robotic lawnmower with the blade disc away from
the body.
Maintenance
• Inspect the robotic lawnmower each week and
replace any damaged or worn parts.
• Check especially that the blades and blade disc
are not damaged. Replace all blades and screws
at the same time if necessary so that the rotating
parts are kept balanced. See
8.6 Replacing the
blades on page 60.
IMPORTANT INFORMATION
Do not lift the robotic lawnmower when it is
parked in the charging station. This may
damage the charging station and/or the
robotic lawnmower. Open the cover and
instead first pull the robotic lawnmower out
of the charging station before lifting it.