Gardena Robotic Lawnmower R40Li - Manual (Page 49)

English - 49
6. MENU FUNCTIONS
Drive past wire
The front of the robotic lawnmower always passes
the boundary wire by a specific distance before the
mower turns around. The default distance is 25 cm,
but this can be changed if required. The minimum
value is 25 cm and the maximum value is 30 cm.
Now specify the number of centimetres you want the
robotic lawnmower to pass the boundary wire and
press OK.
6.5 Security
Through this selection, settings relating to security
and the connection between the mower and the
charging station can be made.
Change PIN code
Enter the new PIN code and press OK. Enter the same
code again and confirm by pressing OK. When the PIN
code is changed, a message stating that the PIN code
has been changed appears in the display momentarily.
Make a note of the new PIN code on the designated
line in Memo on page 4.
Security level
There are three security levels to choose from: low,
medium and high Low and medium security prohibits
access to the robotic lawnmower if the PIN code is
unknown. High security also includes a warning that
beeps if the correct PIN code is not entered after a
designated time period.
Function Low Medium High
Time lock X X X
PIN request X X
Alarm X
IMPORTANT INFORMATION
We recommend using the High security level
at all times.
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire
Change PIN code
Security level
New loop signal
Timer
Installation
Security
Settings
Low
Medium
High
Change PIN code
Security level
New loop signal