Grizzly G0695 - Manual (Page 29)

model g0695 (mfg. since 9/10)
-27-
the headstock can be moved inward or outward
along the ram.
Always lock the ram firmly in place after
adjusting its position. If the headstock slips
during milling operation, the spinning cutter
could bind and break apart, causing serious
personal injury or property damage.
Tools Needed Qty
hex Wrench 8mm .............................................. 1
To move the ram inward or outward:
1. disConnECt miLL From poWEr!
2. Loosen the three recessed cap screws, then
tighten the two raised cap screws slightly to
expand the clamp (see
figure 28).
3. push or pull the headstock in the direction of
desired ram movement.
4. Loosen the two raised cap screws to allow
the clamp to close, then tighten the three
recessed cap screws to tighten the clamp
around the headstock tube.
figure 28. Location of cap screws for adjusting
ram movement.
raised Cap screws
recessed Cap
screws
Clamp
Headstock Ram
Movement
ram