Display, Sonar – Garmin 190-00864-01 User Manual
Page 15
Fishfinder 300C Quick Start Manual
3
Water Temp—sets an alarm to
sound when the transducer reports a
temperature that is 2°F (1.1°C) above
or below the specified temperature.
If you select
On
, press up or down
on the
ROCKER
to select the
temperature, then press
SELECT
.
Battery—sets an alarm to sound when
the battery reaches a user-determined
minimum voltage. If you select
On
,
press up or down on the
ROCKER
to
select the minimum battery voltage,
then press
SELECT
.
Drift—sets an alarm to sound when
the depth changes by the value
specified. If you select
On
, press up
or down on the
ROCKER
to select the
change in drift, then press
SELECT
.
Display
To adjust the backlight or switch
between day and night modes:
From the Home screen, select
Configure
>
Display
.
Backlight—press left or right on the
ROCKER
.
•
•
•
•
Day/Night Mode—press down on the
ROCKER
to highlight the Day/Night
bar. Press left or right on the
ROCKER
to switch between day and night
mode.
Sonar
To change the sonar settings:
From the Home screen, select
Configure
>
Sonar
. Change the sonar settings as
described starting on
System
To change the system settings:
From the Home screen, select
Configure
>
System
.
Beeper—sets beeps to sound during
) or when keys are
pressed. Select
Off
,
Alarms Only
, or
On (Keys & Alarms)
.
Simulator—allows you to practice with
or without a transducer.
NMEA Output—allows the Fishfinder
300C to transmit information to other
NMEA 0183-compatible electronic
equipment.
•
•
•
•