Switching the washer and dryer backsplashes, Warning – GE DPGT750EC/GC User Manual
Page 60
Overview
When viewed from the front, the washer is
shipped for installation on the left and the dryer is
shipped for installation on the right. If the hose
utility connections are arranged so that the units
must be installed with the washer on the right and
the dryer on the left, the backsplashes of the
washer and dryer can be switched in order to
maintain the proper curved appearance.
WARNING!
•
Make sure the washer and dryer are
unplugged.
•
Turn both the home hot and cold water valves
to the off position.
•
Turn the home gas shut-off valve to the off
position (for gas dryer models).
Tools Needed
#2 Screwdriver
Towel (2)
Switching the Washer and Dryer Backsplashes
To switch the washer and dryer backsplashes:
1. Place a towel over the lid of the washer to
prevent scratches to the surface.
2. Remove the 2 screws from the washer
backsplash.
3. Rotate backsplash forward and lift off.
Rear Cover
Screws
4. Remove the 2 screws holding the backsplash
to the rear cover. Remove the backspash
from the rear cover.
Screw
Screw
Rear of Washer