Grizzly H6156 - Manual (Page 8)

Model H6156 Cordless Mini Grinder -6 -
OPERATIONS
Charging the Battery
The Model H6156 is not shipped fully
charged. It will have to be charged for 3
hours before use.
DO NOT charge lon-
ger than this or damage to the battery
may occur!
To charge the battery:
1. Remove the battery from the mini
grinder.
2. Insert the battery into the charger as
shown in Figure 2.
Figure 2. Charging the battery.
Installing Bits
The Model H6156 uses bits and cutters
with an
1 ⁄
8
" diameter shaft. See the Grizzly
catalog or website for a complete listing of
available bits and accessories.
To install a bit:
1. Unplug the tool from the power
source!
2. Depress the collet lock shown in Figure
3 and loosen the collet nut. The collet
lock will engage during rotation, pre-
venting further rotation of the collet nut.
DO NOT completely remove the collet
nut from the shaft.
DO NOT use bits or cutters with a
cutting surface larger than 1". The
bit could break apart under the
stresses of high speed use caus-
ing serious personal injury.
Figure 3. Collet lock.
Collet Lock
3. Plug charger into power source and
allow the battery to charge for 6 hours.
The green light indicates the battery is
charging.
4. Replace battery in mini grinder before
operation.