Grizzly G1029Z2P EN - Manual (Page 21)

g0548zp, g1028z2, g1029z2-z2p (mfg. 12/12+)
-19-
9. Apply the 5 x 42mm wide foam strip to the
outside top of the collector, as shown in
figure 17, and trim the excess so that the
ends of the strip come together evenly, as
shown in
figure 18.
figure 17. Applying the wide foam strip to the
collector.
figure 18. Wide foam strip ends matched
evenly.
Ends matched Evenly
10. place the cleaning handle on the canister
shaft, align the hex bolt with the flat portion
of the shaft and tighten the bolt, as shown in
figure 19.
figure 19. installing the canister cleaning
handle.
Canister shaft Flat
11. position the belt clamp around the base of the
canister, place the canister over the collector
(as shown in
figure 20), then tighten the belt
clamp so it evenly compresses against the
wide foam strip.
figure 20. Canister installed.
Belt Clamp
hex Bolt
Canister
5 x 42mm Foam strip
6 x 20 Foam strip