GIGABYTE 5225 - Manual (Page 42)

- 38 - GA-7N400E(-L) Motherboard
English
SATA/RAID/SCSI Boot Order
This function will available when Boot up device set at "SCSI".
This feature allows you to select the boot order Serial ATA, RAID or SCSI device.
SCSI Select your boot device priority by PCI SCSI.
RAID Select your boot device priority by RAID.
SATAA Select your boot device priority by Serial ATA.
Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is
40 tracks 720K, 1.2M and 1.44M are all 80 tracks.
Enabled BIOS searches for floppy disk drive to determ ine it is 40 or 80 tracks. Note
that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are all
80tracks.
Disabled BIOS will not search for the type of floppy disk drive by track num ber. Note
that there will not be any warning m essage if the drive installed is 360K.
(Default value)
Flexible AGP 8X
Auto Autom atically set AGP transfer rate according to AGP com patibility and
stability. (Default value)
4X Set AGP transfer rate to 4X m ode no m atter what the AGP transfer rate the
card is.
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install an AGP card and a PCI VGA card on board.
PCI Set initial display first to PCI slot. (Default value)
AGP Set initial display first to AGP.