Genie 1022 - Manual (Page 17)

PN# 3642036212, 8/09/2007
17
3b. Wiring (pre-wired).
• Route wire from wall to Safety Beam sensors.
(Fig. 4-5b).
• Splice pre-wiring to shortened sensor wire,
match wire pairs dash-to-dash and
plain-to-plain.
- Trim sensor wire to approximately one foot
(1 ft) from sensor.
- Split and strip ends of sensor wires and
pre-wired wires. (Fig. 4-7)
- Splice wires together with (provided)
wire nuts.
• Route wire from ceiling to power head.
(Fig. 4-5b).
• Securely fasten wires where they exit
wall and ceiling as you go.
– Use insulated staples.
– Staples should be snug only.
4. Split and strip ends of sensor wires (Fig. 4-7).
NOTE: For rear cover locate Box 4.
5. Attach Safety Beam wire to power head wire
terminal.
• Route Safety Beam wires through wire guide.
– Insert wire into terminal holes and lightly press
in the orange locking clips above each terminal
hole. (You can use a pencil or small
screwdriver to comfortably reach in and lightly
press down locking clips.) Insert white wires to
'even' terminal holes and striped wires into
'odd' terminal holes (Fig. 4-8).
– Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
• Install rear cover. The rear cover is the same
color as the power head clips and body
(Fig. 4-9).
• Do not install the white (lamp) cover at this time.
NOTE: Safety Beam alignment check must be
performed following connection to electrical
power (see page 18). DO NOT PLUG IN YET!
Staples which are too tight can cut or pinch wires.
Cut or pinched wires can cause the Safety Beam
System to stop working. When using the insulated
staples, make sure you fasten them only as tightly
as needed to hold the wire snugly.
CAUTION
FIG. 4-7
Splitting and stripping
.
FIG. 4-6 Wire routing .
Wire
Wire
Sensor
Sensor
Invisible Light Beam
Protection Area
Insert Wire
Into Connector
Use this
wire routing
if NOT pre-wired
1 2 3 4
Terminal
Holes
Locking
Clips
5 6
+ –
P B
Infared Sensor
1 2 3 4 5 6
FIG. 4-8
Insert wires.
(Power Head With Rear Cover Not Shown)
FIG. 4-5b Pre-Wired source and sensor wiring
methods .
or 6 5 4 3 2 1 6 5 4 3 2 1
Sensor Source
Red Green
Power
Head Dashed Line = striped wire
Solid Line = white wire
Wall Wall
Ceiling
1/2"
2"
Cover clips
FIG. 4-9 Install rear cover .
Insulated
Staple
Wire Nut