GE 25205 - Manual (Page 39)

Preset Equalizer
To further optimize the sound quality of your speakerphone, it also has an internal audio
equalizer with four available settings. These settings adjust the tone of the speakerphone
to your personal preference. While using your telephone in speakerphone mode, simply
press the Preset EQ button and cycle though these four choices. Pick the one that sounds
the best to you.
1.
FLAT - No equalization adjustment is applied to the tone
2. LOW - Emphasizes the deep rich bass tones of the conversation
3. HIGH - Emphasizes the higher and sharper tones of the conversation
4. VOICE CLARITY - Optimizes your speakerphone tone and sound quality
Like the self-calibration described above, the tone equalizer is only activated when
speakerphone mode is activated. If you press the Preset EQ button while using the
handset or a headset, you will hear an error beep, but there will be no difference in the
tone of the conversation.
Display Messages
The following special messages indicate the status of a message or the unit:
NO CALLS
The CID memory log is empty.
UNKNOWN CALLER The incoming call does not have CID service or their service area
is not linked to yours. If UNKNOWN CALLER appears along with a
calling number, the name information for that number was not
available.
BLOCKED CALL The caller is registered as “Private Number” and their CID
information is withheld.
INCOMPLETE DATA Caller information has been interrupted or corrupted during
transmission.
REPLACE BATTERY You need to replace batteries to prevent data/power loss.
END OF LIST
You are at the beginning or the end of the CID memory log.
Other Information