Global Machinery Company WTS550 - Manual (Page 13)

13
Troubleshooting
Trouble Problem Suggested remedy
Saw will not start Power cord not plugged in Ensure that the cord is connected to the power supply
Power fault, fuse or RCD tripped Check the power supply
Cord damaged Use a qualified electrical repairer to repair or replace
Burned out switch Use a qualified electrical repairer to repair or replace
Faulty motor Use a qualified electrical repairer to repair or replace the motor
Blade does not reach
full speed Extension cord too long or undersized Use extension cord heavy enough to carry the current
Tool is overheating Turn off the tool and let it cool down to room temperature.
Inspect and clean the ventilation slots
Poor cutting Accessory blunted Replace with new circular saw blade
No water on blade (tile cutting only) Ensure water cooling on/off lever is in the “on” position
Vibration or abnormal
noise Loose parts Check to see that all knobs and levers are securely
tightened including bevel adjustment lever, depth locking
lever and parallel fence locking knob
Blade vibrating Ensure that the blade nut is securely tightened
Moving parts excessively worn Use a qualified electrical repairer to repair or replace