Global Machinery Company WTS550 - Manual (Page 10)

10
Operation
Making a straight cut
1. Draw back the table so
there is sufficient space on
the table for the tile.
2. Remove the mitre blocks
3. Line up the cut with the
blade using the scale on
the table.
4. Clamp the work piece in
place using the clamps.
Note. Ensure the tile is not
touching the blade on start up.
5. Switch ON the unit give it a
couple of seconds to reach
full speed and then gently
push the table forward to
the blade until the work
piece is cut through.
6. Pull back the table and
undo the clamps and
remove the cut workpiece.
Note. Do not force the tile
into the blade too quickly or
with excessive force, allow the
blade to do the work.
Making a mitre cut
1. Make sure the unit is switched OFF whilst setting up a
mitre cut.
2. Pull back the table so the mitre cut can be lined up with
the blade.
3. Secure the mitre blocks to rear face of the sliding table.
4. Screw down the clamps into
the surface of the mitre blocks.
5. Clamp down the work piece
onto the sliding table.
6. Switch ON the unit and wait
for it to reach full speed.
7. Slowly push the table forward
until the cut is complete.
8. Pull back the sliding table
and switch OFF the unit to
remove the work piece.