Stovax Stockton 7162 - Manual (Page 23)

23
INsTAllATIoN INsTRUCTIoNs
• Place the main grate into place on the steel runners
The grate must sit flat and locate in the fixing slots in the
supports.
• Refit the firebricks above the grate
• Remove the operating knob and nut from the end of the
rod
• Fit the operating rod to the centre grate
• Feed the operating rod through the hole in the front of
the firebox, while dropping the centre grate into position in
the main grate
• Refit the operating knob and lock into position with the
nut
• Refit the log retainer
• Place the ashpan under the grate.
• Fit the additional door seal to the back of the door as
detailed
• Remove the air control cover fixing bolts
Note how the air slider is assembled for ease of
replacement
• Fix the additional seal to the back of the door
Use the new, longer, fixing bolts to replace the air control
cover. The seal should line-up with the front of the main
grate.
• Check that the door closes correctly.
5B. FITTING MUlTI-FUel KIT To sToVe
(oPTIoNAl) sToCKToN 8 slIMlINe
stockton 8 slimline only
L/H Side Casting
R/H Side Casting
Main Grate
Door Seal (x2)
Ashpan
Ashpan Tool
PR7500
5.1 These instructions cover the fitting of the optional multi-
fuel kit to a wood burning appliance, in order to burn
manufactured smokeless fuels as listed in the User
Instructions.
5.2 To fit the Multi-fuel kit:
• Fit side fire bricks, as detailed in section 3
• Slide the L/H and R/H side castings into position against
the side bricks
• Place the main grate onto the side castings
Ensure the 2 small corner cut-outs are at the front.
• Refit the log retainer
• Place the ashpan under the grate
• Fit the additional seals to the back of each door
Use the one long fixing bolt (new) and one existing fixing
bolt. Note how the cover and air control are fitted to enable
reassembly.
• Pass the additional seal under the front edge of the main
grate
Adjust to ensure the correct fit.
• Check that the door closes correctly