beautypg.com

Garmin STYLUS 3880 User Manual

Page 35

background image

Troubleshooting

35

The message “Could not complete communicating configuration data”
appears when you send settings to the network interface.

Unable to start EpsonNet Config with Web Browser.

The Model Name and IP Address do not appear in the EpsonNet Config dialog
box.

Cause

What to do

This may happen when using a
dial-up router.

Run Command Prompt from the computer on
which EpsonNet Config is installed, and then
enter the following command:

Format: >ROUTE_ADD_the IP address of the
network interface_ the IP address of the
computer (the under bar represents one space)

Example: >ROUTE ADD 192.168.192.168
22.33.44.55.

Cause

What to do

You have not set the IP
address for the network
interface.

Set the IP address for the network interface using
EpsonNet Config or the printer’s control panel.
You can check the IP address by printing a
network status sheet, see “Printing a Network
Status Sheet” on page 19.

Cause

What to do

If a valid IP address is not set,
the items indicated in the
dialog box mentioned above
may not appear.

Set a valid IP address.

Refresh the status by selecting Refresh from the
View menu.

Increase the length of time before a timeout. To
do this, select Options from the Tool menu, and
then select Timeout. Note that doing so can
cause EpsonNet Config to slowly.