GE Monogram ZSAB1 - Manual (Page 8)

MAKING ELECTRICAL CONNECTIONS
• Locate the refrigerator’s AC Input and Output
connectors to the right of the water filter.
• Disconnect the refrigerator’s AC Input and Output
connectors from each other.
NOTE: If possible, try to avoid exposing the wires
attached to the refrigerator’s AC connectors.
MOUNT SWITCHBOX
• FOR PERSONAL SAFETY: Unplug the refrigerator,
remove house fuse or open circuit breaker before
beginning installation.
• Open the grille panel.
• Place a sheet or towel over the top of the fresh food
door to prevent accidentally scratching the door panel.
• Place the switchbox against the left side of the grille
panel opening, placing the switchbox as far toward
the front of the refrigerator as possible.
– Make sure to leave clearance for the door hinge
(if necessary).
– Make sure the green LED light on the side of the
switch box is pointing DOWN.
• Mount the switchbox using the two self-tapping
screws included with the kit.
IMPORTANT: DO NOT DRILL HOLES IN THE SIDE OF
THE REFRIGERATOR. USE THE SELF-TAPPING SCREWS
SUPPLIED WITH THE KIT.
8
Installation Instructions
INSTALLING SABBATH MODE SWITCHBOX
Bottom-Freezer Refrigerators
Sheet or Towel
Refrigerator
AC Connectors
AC
Connector Wire
Screws
DC
Connector
Wire
Green
LED Light