GarrettCom CSG14 User Manual
Page 63
CSG14 Series Gigabit Converter Switch
Installation and User Guide (09/09)
54
www GarrettCom com
.
.
equipped with three (3) screw-down lead posts. The power terminals are identified as
positive (+) and negative (-), and they are floating inside the unit so that the user if desired
may ground either of the terminals. The chassis is “earth” or ground (GND).
The connection procedure is straightforward. Simply insert the DC leads to the
CSG14H’s power terminals, positive (+) and negative (-) screws. The use of Ground
(GND) optional; it connects to the CSG14H chassis. Ensure that each lead is securely
tightened from the top, as shown here.
NOTE: Always use a voltmeter to measure the voltage of the incoming power supply
and figure out the +ve potential lead or -ve potential lead. The more +ve potential lead
will connect to the post-labeled “+ve” and the rest to the “-ve”.
The GND can be hooked up at the last.
When power is applied, the green PWR LED will illuminate.