Installation instructions, Installation, Lighting the studio – Stovax STUDIO 8700CFCHEC User Manual
Page 21
21
INSTALLATION INSTRUCTIONS
INSTALLATION
36
AR1862
• Close the window
5.5 Using the allen key provided:
• Close the window locks by moving from open to shut
towards the window centre
37
AR1860
6. LIGHTING THE STUDIO
Note: The Emergency Shut Off switch must be in the ON
position, refer to Section 2, User Instructions.
There are two ways of lighting the Studio:
• by thermostatic remote control
• using the fire’s touch pad
THERMOSTATIC REMOTE CONTROL
38
AR1883
Turning the Studio On
Your remote can control the gas fire from pilot ignition
through to shut down.
To turn the fire on:
• Press the OFF buton and the UP arrow simultaneously
The pilot and main burner ignite and the remote is now in
Manual Mode. In 'MANUAL MODE' you can:
• turn on the main burner
• regulate the fame from low to high and back
TOUCH PAD CONTROL
39
AR1885
• Press the ON-OFF button to light the appliance, (up to
30 seconds)
• Press the UP button to increase the flame height
• Press the DOWN button to decrease the flame height. At
the lowest point it goes to ‘standby mode’, (only pilot
lit)
• Press the ON-OFF button to turn the appliance off