Installation instructions, Installation, Masonry chimney installation – Stovax STUDIO 8700CFCHEC User Manual
Page 17

17
INSTALLATION INSTRUCTIONS
INSTALLATION
20
AR1862
• Raise the door to almost upright and move the door left
This releases the left-hand side off its hinge pin
• Lower the left-hand side of the door to clear the pin and
move the door to the right to release it from the right pin
The door is now free to remove, Diagram 21
21
AR1863
4.3 • Remove the two enamelled side panels. (Hold the rear
panel whilst removing the second side to prevent it falling).
• Remove the remaining rear and lower panel, Diagram 22
22
AR1865
4.4 • Remove the screw retaining the burner
• Move the burner to the left to disengage the burner
flange from the slot and injector
• Raise the right side and remove the burner, Diagram 23
18
AR1911
The top of the chimney breast must have a minimum
200mm
2
vent.
• Apply a plaster finish to the chimney breast
NOTE: Refer to paragraph 4.11 to check gas pressure
4. MASONRY CHIMNEY INSTALLATION
NOTE: Do not use the legs (of the appliance) in this installation
4.1 • Remove the glass door
Using the allen key provided:
• Release the two window locks.
The locks need to be moved from shut to open towards the
outer edge of the door, Diagram 19.
19
AR1860
4.2 With the door lowered:
• Remove the spring clip from the right-hand hinge pin,
Diagram 20